To Next Page

To Previous Page

9-4

Diagnostics

Factory Defaults

Note If you have downloaded a configuration file and want those setting to take affect after the next reboot,

be sure to clear the Save Configuration check box. Otherwise, the configuration file will be overwritten

and the switch will reboot with the current configuration instead of the downloaded configuration.

■ Select Save Configuration if you want the current configuration to be saved prior to the reboot.

■ Click Reboot Switch to reboot the switch. The current HTTP session is terminated.

Factory Defaults

Two configuration images are kept in system memory: one image contains custom settings; the other

image contains the factory defaults. Use this page to restore all settings to the factory defaults page.

To access this page, click Diagnostics > Factory Defaults.

CAUTION Backup the current configuration file prior to restoring the factory defaults configuration.

See “Backup Manager” on page 10-1 for instructions.

Figure 9-4. Factory Defaults Page

■ Click Reset Configuration to restore the system to the default settings. You can use the

Maintenance > Save Configuration page to ensure that the factory defaults remain in effect after

a reboot. Or, use the Maintenance > Reboot Switch page and ensure that the Save Configuration

check box is selected prior to rebooting.

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 1810G and is the answer not in the manual?

HP ProCurve 1810G Specifications

General