setmib <object-name> <type> <value> [<object-name> <type> <value> …]
This command sets the MIB object defined by object-name. The options for the type
parameter are case sensitive as shown below:
-i Integer
-o Octet string
-d Object identifier
-a IP address (nnn.nnn.nnn.nnn)
-c Counter
-g Gauge
-t Time tick
-u Unsigned integer
-D Display string (“value”)
-N Null
show version
Displays software version information.
show flash
Displays software version information for images in flash.
show tech
Displays switch information needed by HP support for diagnostics.
copy xmodem < startup-config |flash [primary|secondary]>
Retrieves a configuration file using the Xmodem protocol and then writes the
retrieved file to the switch's flash.
copy <startup-config|running-config|crash-log|event-log|crash-rec|Command>
xmodem [ pc | unix ]
Writes either the configuration file, crashrec, eventlog, or the output from a
command specified by command using the Xmodem protocol.
9
To Next Page
Loading...
