Switch Memory and Configuration
Multiple Configuration Files
Listing and Displaying Startup-Config Files
Command Page
show config files Below
show config < filename > 6-27
Viewing the Startup-Config File Status with Multiple
Configuration Enabled
.
Syntax: show config files
This command displays the available startup-config files on
the switch and the current use of each file.
id: Identifies the memory slot for each startup-config file
available on the switch.
act: An asterisk (
* ) in this column indicates that the
corresponding startup-config file is currently in use.
pri: An asterisk (
* ) in this column indicates that the
corresponding startup-config file is currently assigned to the
primary boot path.
sec: An asterisk (
* ) in this column indicates that the
corresponding startup-config file is currently assigned to the
secondary boot path.
name: Shows the filename for each listed startup-config file in
the switch. Refer to “Renaming an Existing Startup-Config
File” on page 6-30 for the command you can use to change
existing startup-config filenames.
For example, show config files displays the following:
6-26
To Next Page
Loading...
