Port Status and Basic Configuration
Using Friendly (Optional) Port Names
■ To retain friendly port names across reboots, you must save the current
running-configuration to the startup-config file after entering the friendly
port names. (In the CLI, use the write memory command.)
Configuring Friendly Port Names
Syntax: interface <port-list> name <port-name-string>
Assigns a port name to port-list.
no interface <port-list> name
Deletes the port name from port-list.
Configuring a Single Port Name. Suppose that you have connected port
A3 on the switch to Bill Smith’s workstation, and want to assign Bill’s name
and workstation IP address (10.25.101.73) as a port name for port A3:
Figure 10-15. Example of Configuring a Friendly Port Name
Configuring the Same Name for Multiple Ports. Suppose that you want
to use ports A5 through A8 as a trunked link to a server used by a drafting
group. In this case you might configure ports A5 through A8 with the name
“Draft-Server:Trunk”.
10-34
To Next Page
Loading...
