File Transfers
Downloading Switch Software
If you do not specify either a primary or secondary flash location for the
destination, the download automatically goes to primary flash.
For example, to download switch software from secondary flash in a switch
with an IP address of 10.28.227.103 to the secondary flash in the destination
switch, you would execute the following command in the destination switch’s
CLI:
Figure A-6. Switch-to-Switch, from Either Flash in Source to Either Flash in
Destination
Using ProCurve Manager Plus to Update Switch
Software
ProCurve Manager Plus include a software update utility for updating on
ProCurve switch products. For further information, refer to the Getting
Started Guide and the Administrator’s Guide, provided electronically with
the application.
A-16
To Next Page
Loading...
