Port Status and Basic Configuration
Overview
Overview
Note On Connecting
Transceivers to
Fixed-Configuration
Devices
This chapter describes how to view the current port configuration and how
to configure ports to non-default settings, including
■ Enable/Disable
■ Mode (speed and duplex)
■ Flow Control
■ Broadcast Limit
■ Auto-MDIX
■ Jumbo Packets
■ QoS Pass-Through Mode
■ Using Friendly (Optional) Port Names
Viewing Port Status and Configuring
Port Parameters
Port Status and Configuration Features
Feature Default Menu CLI Web
viewing port status n/a page 10-6 page 10-8 page 10-17
configuring ports See Table 10-1 page 10-7 page 10-10 page 10-17
on pages 10-4
and 10-5.
If the switch either fails to show a link between an installed transceiver and
another device, or demonstrates errors or other unexpected behavior on the
link, check the port configuration on both devices for a speed and/or duplex
(mode) mismatch. To check the mode setting for a port on the switch, use
either the Port Status screen in the menu interface (page 10-6) or show
interfaces brief in the CLI (page 10-8).
10-3
To Next Page
Loading...
