Troubleshooting
Using Logging To Identify Problem Sources
Shows that Syslog (Destination) logging is
enabled and transmitting log messages to IP
address 18.120.38.155. Also shows that the
logging facility is set to user (the default), and
that session logging is enabled.)
Disables Syslog logging (but retains the
Syslog IP address in the switch
configuration). Does not affect Session
logging.
Shows Syslog (Destination) logging now
disabled. Session logging continues to
operate.
Figure C-10. Example of Disabling Syslog Operation
Viewing Debug (Syslog and Session) Status. Use these commands to
determine the current debug configuration and status:
Syntax: show < config | running >
Lists the current startup-config or running-config file, with
any currently configured IP addresses for SyslogD servers.
ProCurve(config)# show config
Startup configuration:
; J9085A Configuration Editor; Created on release #R.11.XX
hostname “ProCurve switch”
ip default-gateway 18.38.222.1
logging 18.120.38.155
logging 18.120.43.125
vlan 1
name “DEFAULT-VLAN”
snmp-server community “public” Unrestricted
The configured Syslog server IP
addresses appear in the switch’s
configuration file, even if Syslog
logging is disabled.
Figure C-11. Example of Show Config Output with SyslogD Servers Configured
C-30
To Next Page
Loading...
Need help?
General