Hardware options installation 101
Installing the redundant power supply option
1. Power down the server (on page 20).
2. Access the product rear panel (on page 23).
3. Release the power cord from the strain relief clip.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Remove the server from the rack (on page 22).
6. Place the server on a sturdy, level surface.
7. Remove the access panel (on page 24).
8. If installed, remove the secondary PCI riser cage ("Remove the PCI riser cages" on page 26).
9. Remove the Smart Storage Battery holder.
To Next Page
Loading...
