HP ProLiant DL180 Gen9 - 8-Bay SFF Hot-Plug Drive Cage Option

Hardware options installation 45
o
LFF drive
o SFF drive
5. Determine the status of the drive from the drive LED definitions ("Hot-plug drive LED definitions" on
page 18).
6. If removed, install the security bezel ("Security bezel option" on page 41).
To configure arrays, see the HPE Smart Storage Administrator User Guide on the Hewlett Packard
Enterprise website (http://www.hpe.com/info/smartstorage/docs).
8-bay SFF hot-plug drive cage option
For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
To install the component:
1. Power down the server (on page 20).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 20).
o Remove the server from the rack (on page 22).
4. If installed, remove the security bezel ("Remove the security bezel (optional)" on page 23).
5. Remove the access panel (on page 24).