Operations 28
2.
Align the riser board with the corresponding connectors on the system board, and then press down
the PCI riser cage.
3. Push down the release tab, rotate it 180° clockwise, and then press it flat on the PCI riser cage.
o Primary PCI riser cage
o Secondary PCI riser cage
4. Install the access panel (on page 25).
5. Do one of the following:
o Slide the server into the rack.
o Install the server into the rack ("Installing the server into the rack" on page 35).
6. Power up the server (on page 20).
Remove the air baffle
To Next Page
Loading...
