Hardware options installation 57
5.
Remove the primary PCI riser cage ("Remove the PCI riser cages" on page 26).
6. If the 8-bay LFF hot-plug drive cage is currently connected to an HBA, remove the HBA from the
primary PCI riser cage.
7. If the 8-bay LFF hot-plug drive cage is currently connected to the Mini-SAS connectors on the
system board, do the following:
a. Disconnect the existing Mini-SAS cables from the drive backplane and the Mini-SAS connectors
on the system board.
b. Release the Mini-SAS cables from the right front chassis cable clip.
8. Install the storage controller:
a. Identify the riser slot compatible with the new option, and then remove the cover opposite from
that slot.
To Next Page
Loading...
