Hardware options installation 75
a.
Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 20).
o Remove the server from the rack (on page 22).
4. Remove the access panel (on page 24).
5. Remove the air baffle (on page 28).
6. Remove the processor blank.
CAUTION: The pins on the processor socket are very fragile. Any damage to them may
require replacing the system board.
7. Open each of the processor locking levers in the order indicated in the following illustration, and then
open the processor retaining bracket.
To Next Page
Loading...
