Hardware options installation 89
For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
To install the component:
1. Power down the server (on page 20).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 20).
o Remove the server from the rack (on page 22).
4. Remove the access panel (on page 24).
5. If you are installing this PCI riser cage assembly option in the primary PCIe riser location, remove the
default primary PCI riser cage ("Remove the PCI riser cages" on page 26).
6. If you are installing this PCI riser cage assembly option in the secondary PCI riser location, then
remove the secondary PCI riser blank.
Retain the blank for future use.
7. Align the PCI riser board with the corresponding connector on the system board, and then press
down the riser cage.
8. Push down the release tab, rotate it 180° clockwise, and then press it flat on the PCI riser cage.
To Next Page
Loading...
