Removing and replacing the serial port blankRemoving and replacing the serial port blank
CAUTION: CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated
with either a component or a blank.
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a spudger or any small prying tool available.
ProcedureProcedure
1. Remove the serial port blank:
a. Detach the right side of the blank (callout 1).
b. Repeat step a on the left side to remove the blank (callout 2).
2. Immediately install the new serial port blank.
To Next Page
Loading...
