Removing and replacing the DIMM guardRemoving and replacing the DIMM guard
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
ProcedureProcedure
1. If installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove all inner rails from the chassis.
Retain all rails for future use.
8. Remove the access panel .
9. Remove the chassis ear .
10. Remove the front panel cover .
11. If installed, remove the processor air baffle.
To Next Page
Loading...
