Removing and replacing the energy pack holderRemoving and replacing the energy pack holder
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
ProcedureProcedure
1. If physically powering down a server with the front bezel installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. If installed, remove all following components:
Type-a storage controller
Energy pack
9. Remove the energy pack holder.
Retain all screws for future use.
To replace the component, reverse the removal procedure.
To Next Page
Loading...
