Removing and replacing the energy packRemoving and replacing the energy pack
ProcedureProcedure
1. If physically powering down a server with the front bezel installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. If installed, remove the type-a storage controller .
9. Remove the energy pack:
a. Disconnect the energy pack cable (callout 1).
b. Press and hold the release latch (callout 2).
c. Pull up the energy pack (callout 3).
To replace the component, reverse the removal procedure.
To Next Page
Loading...
