Removing and replacing the serial portRemoving and replacing the serial port
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a hex screwdriver available.
ProcedureProcedure
1. If physically powering down a server with the front bezel installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the riser cage.
9. Remove the serial port:
a. Remove the hex screws (callout 1).
b. Detach the serial port from the rear panel (callout 2).
To replace the component, reverse the removal procedure.
To Next Page
Loading...
