Installing the processorInstalling the processor
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION:CAUTION:
THE PINS ON THE PROCESSOR SOCKET AND ON THE PROCESSOR ARE VERY FRAGILE AND EASILY DAMAGED.THE PINS ON THE PROCESSOR SOCKET AND ON THE PROCESSOR ARE VERY FRAGILE AND EASILY DAMAGED. Any
damage to them might require replacing the system board.
PrerequisitesPrerequisites
The processor air baffle (P48355-B21) is required when a processor that has a TDP ≥ 95 W is installed.
Before you perform this procedure, make sure that you have the following items available:
T-15 Trox screwdriver
For heatsink installation, prepare the T-15 Trox screwdriver with preset to 3 in-lb of torque or an adjustable torque screwdriver set
to 3 in-lb of torque.
Alcohol wipe
1.0 gm (0.5 ml) or two 0.5 gm (0.25 ml) of thermal grease
ProcedureProcedure
1. Do not touch the socket contacts or the bottom of the processor.
To Next Page
Loading...
