HP ProLiant DL20 Gen10 Plus - Removing and Replacing a Hot-Plug SAS, SATA or Nvme Drive

Removing and replacing a hot-plug SAS, SATA or NVMe driveRemoving and replacing a hot-plug SAS, SATA or NVMe drive
CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION: CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated
with either a component or a blank.
ProcedureProcedure
1. Back up all server data on the drive.
2. If installed, remove the front bezel .
3. Observe the drive LED status and determine if the drive can be removed.
4. Remove the drive.
LFF drive
SFF drive
To replace the component, reverse the removal procedure.
Removing and replacing a hot-plug SAS, SATA or NVMe drive 83