HP ProLiant DL20 Gen10 Plus - Removing and Replacing the M.2 Air Baffle

Removing and replacing the M.2 air baffleRemoving and replacing the M.2 air baffle
ProcedureProcedure
1. If physically powering down a server with the front bezel installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the M.2 SSD air baffle.
To replace the component, reverse the removal procedure.
Removing and replacing the M.2 air baffle 73