Removing and replacing a LFF non-hot-plug driveRemoving and replacing a LFF non-hot-plug drive
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
Phillips No. 1 screwdriver
ProcedureProcedure
1. If physically powering down a server with the front bezel installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Disconnect all cables from the non-hot-plug drives .
9. Remove the non-hot-plug drive cage assembly.
Retain all screws for future use.
10. Remove the non-hot-plug drive from the drive cage.
Retain all screws for future use.
To Next Page
Loading...
