HP ProLiant DL20 Gen10 Plus - Removing and Replacing an Internal USB Device

Removing and replacing an internal USB deviceRemoving and replacing an internal USB device
ProcedureProcedure
1. If physically powering down a server with the front bezel installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the riser cage.
9. Unplug the USB device from the USB port.
To replace the component, reverse the removal procedure.
Removing and replacing an internal USB device 104