2. Install the processor:
a. Hold the processor by the edges and align the:
Socket notches with the processor notches
Pin 1 indicator on the processor and the socket
b. Lower the processor straight down, without tilting or sliding the processor in the socket.
Make sure that the processor is properly seated in the socket.
CAUTION:CAUTION:
The processor load plate and locking lever should close without resistance. Forcing to close these parts can damage the
processor and the socket. This damage might require replacing the system board.
3. Close the processor load plate (callout 1), and then engage the processor locking lever (callout 2).
To Next Page
Loading...
