HP ProLiant DL380 G3 with MSA1000 User Manual

System Setup and Configuration for Microsoft NT Server 4.0, Enterprise Edition
7. Select Start, Programs, System Tools, Disk Administrator. Review the drive
letters and change if necessary to be the same as the first server.
8. Shut down the second server.
Configuring Cluster Server
To complete the packaged cluster configuration:
1. Power on the first server.
2. Install and configure Microsoft Cluster Server (MSCS).
NOTE: Refer to the Microsoft Windows NT Server 4.0, Enterprise Edition documentation
for details on installing and configuring MSCS.
3. Install Service Pack 6a or later and reboot the server when prompted.
4. Rerun the ProLiant Support Pack for Microsoft Windows NT 4.0 EE to ensure
that the latest HP drivers were not overwritten by the service pack. Reboot if
prompted.
5. Power on the second server and repeat steps 2 through 4 after the first server is
complete.
HP ProLiant DL380 Generation 3 Packaged Cluster Setup and Installation Guide 4-5
HP CONFIDENTIAL Codename: Sopwith Part Number: 252621-002 Last Saved On: 11/8/02 2:08 PM

HP ProLiant DL380 G3 with MSA1000 Specifications

General

Rack Height	2U
Hard Drive Interface	Ultra320 SCSI
Remote Management	Integrated Lights-Out (iLO)
Memory	PC2100 DDR SDRAM
Storage Controller	Smart Array 5i Plus
Network	Dual embedded NC7781 Gigabit NIC
Expansion Slots	6 PCI-X (64-bit/100 MHz)
Form Factor	Rackmount
MSA1000 Storage	External storage enclosure connected via SCSI
RAID Levels	0, 1, 5
Power Supply	Redundant Power Supply Optional
Drive Bays	6 hot-plug SCSI bays
Operating System Support	Windows Server, Linux
Processor	Intel Xeon (up to 3.6 GHz)