System Setup and Configuration for Microsoft NT Server 4.0, Enterprise Edition
4-6 HP ProLiant DL380 Generation 3 Packaged Cluster Setup and Installation Guide
HP CONFIDENTIAL Codename: Sopwith Part Number: 252621-002 Last Saved On: 11/8/02 2:08 PM
Validating the Cluster Configuration
To validate the installation, perform the following steps from either cluster node:
1. Select Start, Programs, Administrative Tools, Cluster Administrator, and
connect to the cluster.
2. Right-click one group. Select Move Group.
3. Verify the group fails over to the other node and all resources come online.
4. Right-click the same group. Select Move Group.
5. Verify that the group fails back to the original node and all resources come
online.
6. Repeat steps 2 through 5 for each group.
Configuration is now complete.
IMPORTANT: If the packaged cluster is being transferred, return to “Setup in the
Configuration Fixture” in Chapter 2 or refer to the packaged cluster hardware installation and
configuration poster to complete the process.
To Next Page
Loading...
