Removal and replacement procedures 32
2.
Connect peripheral devices to the server. For information on identifying connectors, see "SPI board
components (on page 86)."
WARNING:
To reduce the risk of electric shock, fire, or damage to the equipment, do not plug
telephone or telecommunications connectors into RJ-45 connectors.
3. Connect the power cord to the rear of the server.
4. Install the power cord anchors.
5. Secure the cables to the cable management arm.
IMPORTANT: When using cable management arm components, be sure to leave enough
slack in each of the cables to prevent damage to the cables when th
e server is extended from
the rack.
To Next Page
Loading...
