Removal and replacement procedures 32
LFF non-hot-plug drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Back up all server data on the drive.
2. Power down the server (on page 24).
3. If the front bezel is not secured from inside the chassis, open the bezel.
4. If the front bezel is secured from inside the chassis, do the following:
a. Disconnect the power cord from the AC source.
b. Disconnect the power cord from the server.
c. Remove the chassis cover (on page 27).
d. Open the front bezel.
To Next Page
Loading...
