12. Connect the drive power and SAS cables .
13. Slide the LTO tape drive into the media bay until it clicks into place.
14. If removed, install the air baffle .
15. Install the access panel .
16. Install the front bezel .
17. Do one of the following:
Orient the server back in tower mode.
Install the server into the rack .
18. Connect all peripheral cables to the server.
19. Connect each power cord to the server.
20. Connect each power cord to the power source.
21. Power up the server .
22. Perform the configuration procedure required by the drive option.
To Next Page
Loading...
