14. Connect the M.2 SATA SSD cable .
15. Install the PCI blank retainer .
16. Install the air baffle .
17. Install the access panel .
18. Do one of the following:
Orient the server back in tower mode.
Install the server into the rack .
19. Connect all peripheral cables to the server.
20. Connect each power cord to the server.
21. Connect each power cord to the power source.
22. Power up the server .
23. To configure the M.2 SSDs, use Intel VROC. See the OS-specific Intel VROC guide .
To Next Page
Loading...
