HP PROLIANT ML330 G6 - Expansion Hard Drive Cage Option (Hot-Plug)

Hardware options installation 53
3.
Install the hard drive.
4. Determine the status of the drive by observing the drive LEDs ("Hot-plug SATA or SAS hard drive
LEDs" on page 18).
5. Resume normal server operations.
Expansion hard drive cage option (hot-plug)
To install the component:
1. Power down the server (on page 20).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Open or remove the tower bezel" on page 20).
o Extend the server from the rack (on page 21).
3. Remove the access panel (on page 21).
4. Remove the air baffle (on page 22).