Hardware options installation 73
Dedicated iLO 2 port module option
To install the component:
1. Power down the server (on page 20).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Open or remove the tower bezel" on page 20).
o Extend the server from the rack (on page 21).
3. Remove the access panel (on page 21).
4. Using a Phillips screwdriver, remove the dedicated iLO 2 connector module blank.
5. Install the dedicated iLO 2 management port module.
To Next Page
Loading...
Need help?
General