6. Slide the hard drive into the drive housing until it snaps into place (ensure that the pegs on the side of the
drive rails fit into the slot on the drive housing), and then connect the drive cable to the drive.
NOTE: Make sure to tuck the drive cable under the cable restraint.
7. Slide the rear panel drawer assembly into place (taking care that no cables are pinched), ensure that the
drawer assembly is seated firmly against the chassis, and then tighten the thumbscrews.
8. Reconnect the power and Ethernet cables, and, optionally, the cable-style lock, and then press the Power
button to turn on the product.
ENWW Replace the hard drive 95
To Next Page
Loading...