1. At the product control panel, touch the Administration button, touch the Network Settings menu, touch
the Embedded Jetdirect Menu option, touch the TCP/IP option, touch the IPV4 Settings option, and then
touch the Config Method option.
2. Touch Manual, and then touch Save.
3. Touch the Back button
to return to the IPv4 Settings screen.
4. On the IPv4 Settings screen, touch Manual Settings, and then touch the option you wish to manually set
and follow the onscreen instructions to change the option setting.
5. Touch the Back button
repeatedly until you return to the Embedded Jetdirect Menu.
6. Touch the Link Speed option.
7. Touch one of the following options.
Setting Description
Auto The product automatically configures itself for the highest link speed and
communication mode allowed on the network.
10T Half 10 megabytes per second (Mbps), half-duplex operation
10T Full 10 Mbps, full-duplex operation
100TX Half 100 Mbps, half-duplex operation
100TX Full 100 Mbps, full-duplex operation
100TX Auto Limits auto-negotiation to a maximum link speed of 100 Mbps
1000T Full 1000 Mbps, full-duplex operation
8. Touch the Save button.
Manually configure IPv6 TCP/IP parameters from the control panel
In addition to using the Embedded Web Server, you can also use the control-panel menus to set an IPv6 address.
1. At the product control panel, touch the Administration button, touch the Network Settings menu, touch
the Embedded Jetdirect Menu option, touch the TCP/IP option, touch the IPV6 Settings option, touch the
Address option, touch the Manual Settings option, and then touch the Enable option.
2. Touch the On option, and then touch the Save button.
3. Touch the Address option, and then touch the data entry field.
4. Use the keyboard to enter the address, and then touch the Save button.
Disable network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols has the following
benefits:
●
Decreases product-generated network traffic
●
Provides only pertinent information on the configuration page
●
Allows the product control panel to display protocol-specific error and warning messages
30 Chapter 3 Administration - Configure the product ENWW
To Next Page
Loading...