Link speed and duplex settings
The link speed and communication mode of the product must match the network. For most situations, leave
the product in automatic mode. Incorrect changes to the link speed and duplex settings might prevent the
product from communicating with other network devices. If you need to make changes, use the product control
panel.
NOTE: Making changes to these settings causes the product to turn off and then on. Make changes only when
the product is idle.
1. At the product control panel, touch the Administration button, touch the Network Settings menu, and then
touch the Jetdirect Menu option.
2. Touch the down arrow until the Link Speed option displays.
3. Touch the Save button. The product turns off and then on.
ENWW Basic configuration using the Administration menu 31
To Next Page
Loading...