i. Detach the sensor board (5) from the display back cover. The sensor board is attached to the
display back cover with double-sided adhesive.
j. Remove the sensor board.
The sensor board is available using spare part number N10918-001.
19. To remove the hinges:
a. Remove the display assembly.
b. Remove the display bezel.
c. Remove the display panel assembly.
d. Remove the six Phillips M2.5 × 6.1 screws (1) that secure the hinges to the display panel
assembly.
e. Remove the hinges (2).
The hinges are available using spare part number N10932-001.
To reassemble and replace the display assembly, reverse the removal procedure.
Display assembly
61
To Next Page
Loading...
