4. Remove the battery (see Battery on page 46).
5. Remove the fans (see Fans on page 49).
6. Remove the heat sink (see Heat sink on page 49).
7. Remove the system board (see System board on page 62).
Remove the fingerprint reader cable:
1. Release the ZIF connector (1) the fingerprint reader cable is connected to, and then disconnect the
fingerprint reader cable from the fingerprint reader.
2. Release the ZIF connector (2) the fingerprint reader cable is connected to, and then disconnect the
fingerprint reader cable from the transfer board.
3. Detach the fingerprint reader cable (3) from the computer. The fingerprint reader cable is attached
to the computer with double-sided adhesive.
4. Remove the fingerprint reader cable.
To install the fingerprint reader cable, reverse the removal procedure.
Fingerprint reader
To remove the fingerprint reader, use this procedure and illustration.
Table 5-10
Fingerprint reader description and part number
Description Spare part number
Fingerprint reader
NOTE: The fingerprint reader spare part kit does not include the fingerprint reader bracket or the
fingerprint reader cable. The fingerprint reader bracket is included in the Bracket Kit, spare part
number N10940-001. The fingerprint reader cable is included in the Cable Kit, spare part number
N10935-001.
N10920-001
Before removing the fingerprint reader, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 40).
68
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
Need help?
General
