HPE 3PAR StoreServ

Accessing SPMAINT
SPMAINT allows you to affect the current status and configuration of both the system and the SP. For this
reason, only one instance of SPMAINT can be run at a time on a given system.
To access SPMAINT:
Procedure
1. Add the hosts to the firewall or leave the firewall in Permissive mode. (Firewall settings can be
changed on the 2.3 menu of SPMAINT.)
2. Initiate an SSH session to establish a connection to your SP.
3. Enter your user name and password.
SPMAINT Interface
Use the SPMAINT terminal user interface to support both the system and its SP. The following figure
illustrates the SPMAINT interface.
SP0001400383
1 SP Main
HPE 3PAR Service Processor Menu
Transfer media: ethernet Transfer status: Ok
Enter Control-C at any time to abort this process
1 ==> SP Control/Status
2 ==> Network Configuration
3 ==> StoreServ Configuration Management
4 ==> StoreServ Product Maintenance
5 ==> Local Notification Configuration
6 ==> Site Authentication Key Manipulation
7 ==> Interactive CLI for a StoreServ
8 ==> Execute a command on a node
X Exit
The following information appears at the top of each SPMAINT menu:
• SP ID
—The SP ID uses one of several formats:
◦ 7-character SP ID---The literal “SP” string (2 characters) + 5 digits (for example, SP09997). This ID
format is used for legacy SPs.
◦ 12-character SP ID---
– The literal “SP000” string (5 characters) + the 3PAR StoreServ 7000 7-digit 3PAR serial number
that is located on a label affixed to the node enclosure (DCN1). The label is on a tab on the
back right of the enclosure near Power Cooling Module1 (PCM 1, the PCM on the right). For
14 Overview