NOTE: With IE version 11.0.9600.19129, when you try to add vCenter to the SP through SPOCC; system
is unresponsive and vCenter is not added to the SP. Update the IE to11.2248.14393.0. and try adding
vCenter again or use Firefox to add vCenter to the SP.
Using SPOCC, you can add a StoreServ Storage system to SP and add vCenter to the existing Storage
system or newly added Storage System.
Add vCenter to the new StoreServ
SPOCC provides an option to add vCenter while adding a new StoreServ Storage system to SP.
Procedure
1. Connect to SPOCC with the SP IP address. Enter the SP IP address into a supported browser and
login with a valid username and password.
2. In the left navigation pane, click SPmaint.
3. Under Service Processor - SP Maintenance, click StoreServ Configuration Management.
4. Under Service Processor - StoreServ Configuration, click Add StoreServ.
5. Enter the IP address and the Super user credentials (account and password).
StoreServ Configuration Management 35
To Next Page
Loading...
