3. Make any additional changes to the SP phone number and dial-in prefix as necessary.
4. When finished, enter A, then press ENTER to quit, save, and activate the new transfer media settings.
Changing the Remote Operations Transfer Media
Use this option to alter the media the SP uses when conducting problem-solving activities and diagnostics
performed from a remote location.
To change the remote operations transfer media:
Procedure
1. From the SP Transfer Media submenu, enter 2 for Remote Operations, then press ENTER.
The SP Transfer Media Configuration menu for remote operations appears.
2. Enter E|e for Ethernet, M|m for modem, or O|o for off, then press ENTER.
The SP Transfer Media submenu appears.
NOTE: The SP Transfer Media submenu may show additional items. Changed options appear to the
right of the current values.
3. Make any additional changes to the SP phone number and dial-in prefix, if applicable.
4. When task is complete, enter A, then press ENTER to quit, save, and activate the new remote
operations transfer media settings.
32 Network Configuration
To Next Page
Loading...
