9. NIC port 2; Service port (Eth1)
10. NIC port 1; Management port (Eth0)
11. iLO Management Port
12. Serial port (optional)
13. USB 3.0 ports
14. FlexibleLOM (optional)
The port configuration for the DL360 Gen10 on the front side is as follows:
1. Serial label pull tab
2. Display port (optional)
3. Optical drive (optional)
4. USB 2.0 port (optional)
5. USB 3.0 port
6. iLO Service Port
7. SAS/SATA drive bays
The front side illustration shown above is for 8 LLF drive configuration and the location of Service Port
may vary depending on the configuration of the HPE DL360 Gen10 system.
8 Introduction
To Next Page
Loading...
