HPE FlexNetwork MSR958

92
NTP commands
NTP is supported on the following Layer 3 interfaces:
• Layer 3 Ethernet interfaces.
• Layer 3 Ethernet subinterfaces.
• Layer 3 aggregate interfaces.
• Layer 3 aggregate subinterfaces.
• VLAN interfaces.
• Tunnel interfaces.
display ntp-service ipv6 sessions
Use display ntp-service ipv6 sessionsto display information about all IPv6 NTP associations.
Syntax
display ntp-service ipv6 sessions [ verbose ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
verbose: Displays detailed information about all IPv6 NTP associations. If you do not specify this
keyword, the command displays only brief information about the IPv6 NTP associations.
Examples
# Displaybrief information aboutall IPv6 NTP associations.
<Sysname>display ntp-service ipv6 sessions
Notes: 1 source(master), 2 source(peer), 3 selected, 4 candidate, 5 configured.
Source: [125]3000::32
Reference: 127.127.1.0 Clock stratum: 2
Reachabilities: 1 Poll interval: 64
Last receive time: 6 Offset: -0.0
Roundtrip delay: 0.0 Dispersion: 0.0
Total sessions : 1