HPE FlexNetwork MSR958

431
Usage guidelines
Version 9 is template-based and supports user-defined formats. A NetStream device must send the
version 9 templates to NetStream servers regularly, because the servers do not permanently save
templates.
You can configure the refresh frequency or refresh interval for the device to send version 9 templates.
If both settings are configured, templates are sent when either of the conditions is met.
To configure the refresh interval for version 9 templates, use the ip netstream export v9-template
refresh-rate time command.
Examples
# Configure the device to send version 9 templates to NetStream servers every 100 packets.
<Sysname> system-view
[Sysname] ip netstream export v9-template refresh-rate packet 100
Related commands
ip netstream export v9-template refresh-rate time
ip netstream export v9-template refresh-rate time
Use ip netstream export v9-template refresh-rate time to configure the sending interval for
version 9 templates.
Use undo ip netstream export version to restore the default.
Syntax
ip netstream export v9-template refresh-rate time minutes
undo ip netstream export v9-template refresh-rate time
Default
Version 9 templates are sent every 30 minutes.
Views
System view
Predefined user roles
network-admin
Parameters
minutes: Specifies the refresh interval in the range of 1 to 3600 minutes.
Usage guidelines
Version 9 is template-based and supports user-defined formats. An NetStream device must send the
version 9 templates to NetStream servers regularly, because the servers do not permanently save
templates.