HPE FlexNetwork MSR958

168
Predefined user roles
network-admin
Parameters
profile-name: Specifies a PoE profile name, a case-sensitive string of 1 to 15 characters. A PoE
configuration file name begins with a letter and must not contain reserved keywords including undo,
all, name, interface, user, poe, disable, max-power, mode, priority, or enable.
index: Specifies the index number of a PoE profile, in the range of 1 to 100.
Usage guidelines
To configure PIs in batches, use the PoE profile.
If you do not specify a profile index, the system automatically assigns an index (starting from 1) to the
PoE profile.
If a PoE profile is applied, use the undo apply poe-profile command to remove the application
before deleting the PoE profile.
Examples
# Create a PoE profile, name it abc, and specify the index number as 3.
<Sysname> system-view
[Sysname] poe-profile abc 3
[Sysname-poe-profile-abc-3]
# Create a PoE profile and name it def. Do not specify the index number.
<Sysname> system-view
[Sysname] poe-profile def
[Sysname-poe-profile-def-1]
Related commands
apply poe-profile
poe enable
poe max-power
poe priority
poe utilization-threshold
Use poe utilization-threshold to configure a power alarm threshold for a PSE.
Use undo poe utilization-threshold to restore the default power alarm threshold of a PSE.
Syntax
poe utilization-threshold value pse pse-id
undo poe utilization-threshold pse pse-id
Default
The power alarm threshold for the PSE is 80%.