479
info-center diagnostic-logfile directory
Use info-center diagnostic-logfile directory to configure the directory to save the diagnostic log
file.
Syntax
info-center diagnostic-logfile directory dir-name
Default
Diagnostic log files are saved in the diagfile directory under the root directory of the storage device.
Views
System view
Predefined user roles
network-admin
Parameters
dir-name: Specifies a directory by its name, a string of 1 to 64 characters.
Usage guidelines
The specified directory must have been created.
This command cannot survive a reboot. (Centralized devices in standalone mode.)
This command cannot survive a reboot or an active/standby switchover. (Distributed devices in
standalone mode.)
This command cannot survive an IRF reboot or a master/subordinate switchover. (Centralized
devices in IRF mode.)
This command cannot survive an IRF reboot or a global active/standby switchover in an IRF fabric.
(Distributed devices in IRF mode.)
Examples
# Set the diagnostic log file directory to flash:/test.
<Sysname> mkdir test
Creating directory flash:/test... Done.
<Sysname> system-view
[Sysname] info-center diagnostic-logfile directory flash:/test
info-center diagnostic-logfile enable
Use info-center diagnostic-logfile enable to enable saving diagnostic logs to the diagnostic log
file.
Use undo info-center diagnostic-logfile enable to disable saving diagnostic logs to the diagnostic
log file.
To Next Page
Loading...
