492
Syntax
info-center security-logfile directory dir-name
Default
The security log file is saved in the seclog directory under the root directory of the storage device.
Views
System view
Predefined user roles
security-audit
Parameters
dir-name: Specifies a directory by its name, a string of 1 to 64 characters.
Usage guidelines
The specified directory must have been created.
To use this command, a local user must be authorized the security-audit user role. For information
about configuring the security-audit user role, see Security Command Reference.
This command cannot survive a reboot. (Centralized devices in standalone mode.)
This command cannot survive a reboot or an active/standby switchover. (Distributed devices in
standalone mode.)
This command cannot survive an IRF reboot or a master/subordinate switchover. (Centralized
devices in IRF mode.)
This command cannot survive an IRF reboot or a global active/standby switchover in an IRF fabric.
(Distributed devices in IRF mode.)
Examples
# Set the security log file directory to flash:/test.
<Sysname> mkdir test
Creating directory flash:/test... Done.
<Sysname> system-view
[Sysname] info-center security-logfile directory flash:/test
info-center security-logfile enable
Use info-center security-logfile enable to enable saving of security logs to the security log file.
Use undo info-center security-logfile enable to restore the default.
Syntax
info-center security-logfile enable
undo info-center security-logfile enable
To Next Page
Loading...
