HPE FlexNetwork MSR958

456
ipv6 netstream export v9-template refresh-rate time
Use ipv6 netstream export v9-template refresh-rate time to configure the sending interval for
IPv6 NetStream version 9 templates.
Use undo ipv6 netstream export v9-template refresh-rate time to restore the default.
Syntax
ipv6 netstream export v9-template refresh-rate time minutes
undo ipv6 netstream export v9-template refresh-rate time
Default
Version 9 templates are sent every 30 minutes.
Views
System view
Predefined user roles
network-admin
Parameters
minutes: Specifies the interval in the range of 1 to 3600 minutes.
Usage guidelines
Version 9 is template-based and supports user-defined formats. An IPv6 NetStream device must
send the version 9 templates to NetStream servers regularly, because the servers do not
permanently save templates.
You can adjust the refresh frequency or refresh interval for the device to send version 9 templates. If
both settings are configured, templates are sent when either of the conditions is met.
To configure the refresh frequency for version 9 templates, use the ipv6 netstream export
v9-template refresh-rate packet command.
Examples
# Configure the device to send version 9 templates every 60 minutes.
<Sysname> system-view
[Sysname] ipv6 netstream export v9-template refresh-rate time 60
Related commands
ipv6 netstream export v9-template refresh-rate packet
ipv6 netstream export version 9
Use ipv6 netstream export version 9 to export IPv6 NetStream data in the version 9 format and
choose whether to record AS and BGP next hop information.
Use undo ipv6 netstream export version to restore the default.