HPE FlexNetwork MSR958

467
Parameters
length: Specifies the maximum number of bytes that can be copied, in the range of 18 to 512. As a
best practice, use the default value.
Examples
# Set the maximum number of bytes to 60 for flow sampling to copy per packet on GigabitEthernet
1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] sflow flow max-header 60
sflow sampling-mode
Use sflow sampling-mode to specify a flow sampling mode.
Use undo sflow sampling-mode to restore the default.
Syntax
sflow sampling-mode determine
undo sflow sampling-mode
Default
Fixed sampling mode is used.
Views
Layer 3 Ethernet interface view
Predefined user roles
network-admin
Parameters
determine: Specifies the fixed sampling mode. For example, if the flow sampling interval is set to
4000 (by using the sflow sampling-rate command), the device samples packets as follows:
• The device randomly samples a packet, like the tenth packet, from the first 4000 packets.
• The next time the device samples the 4010th packet, and so on.
Examples
# Specify fixed flow sampling mode on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] sflow sampling-mode determine
Related commands
sflow sampling-rate