HPE FlexNetwork MSR958

150
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
pse pse-id: Specifies a PSE ID. To display PSE ID and slot mappings, use the display poe device
command.
Examples
# Display the status of all PIs on PSE 7.
<Sysname> display poe pse 7 interface
Interface PoE Priority CurPower Oper IEEE Detection
(W) Class Status
GE1/0/1 Enabled Low 4.4 On 1 Delivering
Power
GE1/0/2 Enabled Critical 0.0 Power-lack - Disabled
GE1/0/3 Enabled Low 0.0 Power-deny - Disabled
GE1/0/4 Enabled Critical 0.0 On - Searching
GE1/0/5 Enabled Low 4.0 Power-limit 2 Delivering
Power
GE1/0/6 Enabled Low 0.0 Power-itself - Disabled
GE1/0/7 Disabled Low 0.0 Off - Fault
--- On State Ports: 2; Used: 8.4(W); Remaining: 171.6 (W) ---
Table 27 Command output
Field Description
Interface Interface name of a PI.
PoE
PoE status of a PI:
• Enabled.
• Disabled.
Priority
Priority of a PI:
• Critical (highest).
• High.
• Low.
CurPower Current power of a PI.