CAUTION: If installing a processor with a faster speed, update the system ROM before
installing the processor.
To download firmware and view installation instructions, see the Hewlett Packard Enterprise
Support Center website.
CAUTION: THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. To avoid
damage to the socket or processor, do not touch the contacts.
2. If installed, remove the bezel.
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
6. Remove the access panel.
7. If installed, remove the air baffle.
8. Remove the heatsink.
9. Using an alcohol wipe, remove the existing thermal grease from the heatsink. Allow the alcohol to
evaporate before continuing.
10. Remove the processor:
a. Unscrew the three force frame screws in the order indicated.
b. Pivot the rail frame to the upright position.
c. Slide the processor out of the rail frame.
78 Removal and replacement procedures
To Next Page
Loading...
